Vari-grind 2 instructions

vari grind jig angle
wolverine jig base
fingernail gouge grinding jig
wolverine bowl gouge sharpening
long grind bowl gouge
www oneway ca multi media htmellsworth grinding jig
wolverine jig plans

Speed handle. 2 Bases. 1 vee-arm. 1 platform. For your new ONEWAY. Wolverine Grinding Jig to work . The Vari-Grind Attachment will easily and consistently.instruction sheets recommended. Vari-Grind jig, as shown above. You 2". 6". Center line of grinding wheel. Rest on the arm of the sharpening jig. 5/8. / ". The NEW Vari-Grind 2 restrains tool motion in two directions. The side to side motion of the tool is restrained so that the tool cannot slip off the side of the wheel. 29 Sep 2013 Remove the jig from the grinding wheel and insert the tool into the Vari-Grind 2 Jig. 2. Insert the tool into the block of wood 3. Push the Vari-Grind 2 jig up to the block and tighten the screw. By doing this, you will ensure the steel coming out of the Vari-Grind 2 jig is the exact same distance each time. So, I started looking at the Vari-Grind 2. I do have a template for a guide you make from plywood or masonite or something - I think I got it from 15 Sep 2009 I seek your tips, and instructions for getting the best edge using my Wolverine Varigrind #2 jig. As my efforts are not paying dividends, and I am With the Vari-Grind 2 there are now two ways of setting the angle of the adjusting leg. Method 1 is the graduations on the back of the toolholder and are covered 17 Dec 2016 Just got the Wolverine setup and got the Vari-Grind 2 while I was at it. The box (for the Vari-grind) came with the same DVD as the base kit and To grind into the "down" p You may the tool s get enoug or other way. The Vari-Grind in the "up" position grinding a fingernail profile. All tools ground using the Vari-Grind can use the same setting block. Dimension "A" should be between 1-3/8" and 2", with 1-3/4" being just about ideal. 1 Jun 2015