Ufc 3 200 01dryvit eifs installation instructions -431-

UNIFIED FACILITIES CRITERIA (UFC) UFC 1-200-01 continuous air barrier is in place and installed without failures in accordance with installation instructions so that repairs to the continuous air barrier, if needed to comply with the required air leakage rate, can be done in a timely manner The kit includes 4.5 lbs of our specially blended fiber glass based EIFS (Exterior Insulation and Finish System) material, mix container, stir paddle, trowel, float, gloves, paint brush, razor knife, foam, fiberglass mesh, AR glass fibers, 3.5 lbs. Fine Finish, 3.5lbs. Dryvit Outsulation X System Application Instructions. DS836 2. Dryvit Outsulation X System Installation Details, DS837 3. Dryvit Outsulation X System Data Sheet, DS834 B. Related Sections 1. Unit Masonry - Section 04200 (EIFS) or EIFS with Drainage 33. ASTM G 154 Standard Practice for General structural requirements for DoD projects are provided in the UFC 1-200-01 standard. The current model building code referenced is the 2012 IBC. Specific structural design criteria are also listed for all major military bases. UFC 4-010-01 specifically states that its requirements do not supersede the structural requirements of UFC 1-200-01. Specification For Backstop NT For Use Beneath Claddings Other Than use, and installation of the Dryvit Backstop NT - Smooth or Texture air/water-resistive barrier. This document is intended to be used in Backstop NT For Use Beneath Claddings Other Than Dryvit EIFS DS200 3 RESIDENTIAL BUILDER'S REFERENCE GUIDE application instructions and details. Copies of AN EIFS INSTALLATION AMBIENT TEMPERATURE REQUIREMENTS A minimum temperature of 4 °C (40 °F) and rising during installation and 24 hours thereafter shall be maintained. Always use the latest version of the ParexUSA Application Guide. This guide focuses on the Protecting the System After Installation 19 Special Instructions for Mechanically Fastened CI Systems 21. 1 1. PRODUCTS These requirements are essential to good Continu