Slave cylinder ford ranger 1998 manual transmission

The average cost for a Ford Ranger clutch replacement is between $778 and $920. Labor costs are estimated between $459 and $580 while parts are priced between $319 and $340. How to Bleed a Slave Cylinder. The slave cylinder is part of the hydraulic clutch system in vehicles with manual transmissions. When the master cylinder or the slave cylinder starts leaking fluid, it must be replaced along with the fluid. Ford-Rangers.com Ranger Forum > Tech Section > Drivetrain Tech > Where to find OEM slave cylinder Ford-rangers.com is a discussion forum, a Ranger forum for people who have questions about fixing or modifying Slave cylinder leaks aren't likely to cause this as a stand alone issue. Still, if there's no fluid in the lines and no other cause is identified, it could be the slave cylinder. We deal with many Ford Ranger clutch kits. Thanks to this, we get to spend some time talking to Ranger owners about their clutch system problems. Need to know the type of fluid your Ford Ranger needs? Here is a Ford Ranger Fluids and Capacities chart: 1991-1996 Ford Ranger use Mercon Automatic Transmission Fluid. 1997-2011 Ford Ranger use Mercon V Automatic Transmission Fluid 4.0L SOHC Manual Transmission — 13.5 quarts. 4.0L Ford Ranger Gas 1998, Clutch Slave Cylinder by RhinoPac®. Replace your leaking or worn clutch slave cylinder and shift properly again. This part is constructed from heavy duty material for extended service life and ensures just the same The hydraulic slave cylinder line on your Ford Ranger, which is attached to the slave cylinder, is necessary for operating the truck's hydraulic system. If the slave cylinder fails, the hydraulic line will need to be removed to replace the slave cylinder. It take about 30 minutes to remove the hydraulic slave Looking for a 1998 Ford Ranger Clutch Slave Cylinder? Get yours at Wholesale Prices and Free Shipping over $50 only here at AutoPartsWarehouse! This is a fully synchronized 5-Speed manual transmission with a fifth gear overdrive. It has a stamped metal pan on the bottom much like an automatic transmission and the main case is tapered toward the rear. the slave cylinder fails to release the clutch completely. If you are having Ford Ranger Transmission Questions sounds like there is a pretty good chance slave cylinder is going on ya. i have an 2003 ranger 4x4 with the 4.0. mine acted a fool for about three months and finally left me stranded at work at 2 am none the less. i did the hole bleeding thing and it helped 1998 Ford Ranger XLT manual transmission problem 1 Answer. I have a 1998 Ford Ranger XLT and my transmission is starting to slide when I try to step on the gas it just revs up and then when I Let Go is when the gear kind of grabs I wanted to know what mig After draining the system of fluid, the slave cylinder and master cylinder will be removed from the vehicle, by disconnecting the slave cylinder from the transmission bell housing, and removing the master cylinder from the firewall. The clutch hydraulic line should be removed with the slave cylinder and clutch master cylinder. After draining the system of fluid, the slave cylinder and master cylinder will be removed from the vehicle, by disconnecting the slave cylinder from the transmission bell housing, and removing the master cylinder from the firewall. The clutch hydraulic line should be removed with the slave cylinder and clutch master cylinder. Symptoms of a Bad or Failing Clutch Slave Cylinder.