Drash heater manualpertronix 1181ls installation instructions

This manual provides installation, operation, maintenance, and service information for these heaters. If your heater has been installed correctly, operating the heater is an easy task. The upper front panel of the heater contains the control center that allows you to turn the heater On or Off and adjust the temperature set-tings for the pool or B. Installation Instructions: "Cautions" - The installation, location, position and orientation of the add-on heater must conform to the following: 1) This heater must be installed downstream of the furnace in the warm air plenum. 2) This heater must be installed downstream of the furnace safety limit control. 1181LS. Fits 8 cyl GM Delco. Lobe Sensor Model, Mechanical Advance, Excludes 215/300 cid, F or over 40 years, the Ignitor has proven itself in applications ranging from race cars to tractors. The Ignitor replaces breaker point and troublesome factory electronic ignitions with a dependable, self contained and maintenance free electronic ignition system. With a water-tight control panel, the D-1000B heater was designed to operate in all different types of environmental conditions. A pre-heated fuel filter allows heater to work at extreme low temperatures. When operating the D-1000B heater, the noise level when measured at a distance of 3' (Ft) from the control panel is 76dB. Mustang Pertronix Ignitor III Ignition (1965-1974) Installation Instructions. plug wires and heater hoses for ease of installation and clarity. The installation can be done with these parts in place by just pushing them up and out of the way. See below for additional instructions instructions. The heater must be supported by materials having a working load limit of at least 115lbs. • Supply the owner with a copy of these Installation and Operation Instructions. • Where unvented heaters are used, gravity or mechanical means shall be provided to supply and exhaust at least 4 CFM per 1,000 Btu/hr input of installed Bill shows you how to i